Digiflow 8100 LCD flow meter time/liter monitoring COD: CL-330230

Flow meter with external turbine, TEMPO-VOLUME type, measures the flow of water in litres or gallons.
• Inlet – outlet: 1/4″ BSP male

Characteristics:
– Filter autonomy control (from 500 to 99500 litres);
– Control of elapsed time (from 30 to 720 days);
– Flow rate display (0.8 -8.0 lpm);
– Filter life almost finished warning with alarm;
– Filter life-end alarm warning;
– Low battery warning alarm;
– Automatic data saving when device is turned off.

Application:
– Undercounter water treatment system;
– Commercial water treatment system;
– Water dispenser.

BATTERY INSTALLATION
Slide off the battery compartment cover and insert 2 AA batteries. Close the cover.

CAPACITY AND TIME SETTING
Press and hold the DISPLAY together with the RESET button and release both buttons. The DigiFlow 8100T will enter the filter capacity registration procedure. The flashing digit on the display will indicate that the procedure has started and that the setting is active.

CONNECTIONS
The DigiFlow8100T connections are 1/4” BSP male.

CAPACITY SETTING
Press DISPLAY to choose the filter capacity. The sequence is 500-1000…99500-OFF-0-500.
After choosing the correct capacity press RESET to save the setting.

TIME SETTING
By holding DISPLAY you can speed up the selection sequence. The sequence is 30-60-90-120…-OFF-0-30. After choosing the correct capacity press RESET to save the setting. The setting procedure is completed.
* Capacity mode will be disabled when OFF is selected.
** The setup procedure will be terminated and return to the original state if there is no input for 10 seconds.

OPERATIONS
The DigiFlow 8100T will automatically turn on when water passes through.
It will automatically turn off after 10 seconds if there is no water flow.

DISPLAY BUTTON
Press the display key to view the status of the three modes of the DigiFlow 8100T. Capacity mode: Shows the remaining capacity in liters or gallons. Time mode: Shows the remaining times. Flow rate mode: Shows the current flow rate. The sequence is Flow rate – Time – Capacity.

RESET BUTTON
Press RESET to turn off the alarm and reset the filter capacity.

ALARM – Notification from alarm
When the capacity is less than 100 gallons (380lt.) or the time remaining is less than 7 days, the buzzer will sound and the display will flash to alert you that the cartridge needs to be changed. The alarm will repeat every time water flows through the DigiFlow 8100T or every time the DISPLAY button is pressed.

ALARM
When the capacity reaches 0 gallons or the time reaches 0 days, the Digiflow will produce an audible alarm to alert the user to change cartridges or press the display button.

LOW BATTERY ALARM
When the battery power is lower than the normal working level, a buzzer will beep twice to remind you to change the batteries. The information will be retained in memory if the battery is completely discharged or removed.